Switching Commands
179
ProSafe Managed Switch
Example: The following shows example CLI display output for the command.
(Switch) #show lldp remote-device detail 0/7
LLDP Remote Device Detail
Local Interface: 0/7
Remote Identifier: 2
Chassis ID Subtype: MAC Address
Chassis ID: 00:FC:E3:90:01:0F
Port ID Subtype: MAC Address
Port ID: 00:FC:E3:90:01:11
System Name:
System Description:
Port Description:
System Capabilities Supported:
System Capabilities Enabled:
Time to Live: 24 seconds
show lldp local-device
Use this command to display summary information about the advertised LLDP local data.
This command can display summary information or detail for each interface.
Format show lldp local-device {<unit/slot/port> | all}
Mode
Port ID
The port number that transmitted the LLDPDU.
System Name
The system name of the remote device.
System
Description
Describes the remote system by identifying the system name and versions of hardware,
operating system, and networking software supported in the device.
Port
Description
Describes the port in an alpha-numeric format. The port description is configurable.
System
Capabilities
Supported
Indicates the primary function(s) of the device.
System
Capabilities
Enabled
Shows which of the supported system capabilities are enabled.
Management
Address
For each interface on the remote device with an LLDP agent, lists the type of address the
remote LLDP agent uses and specifies the address used to obtain information related to
the device.
Time To Live
The amount of time (in seconds) the remote device's information received in the
LLDPDU should be treated as valid information.
Privileged EXEC
Term Definition
To Next Page
Loading...
Need help?
General