NETGEAR ProSAFE M7100-24X - Ip Pim Dr-Priority; Ip Pim Join-Prune-Interval; Ip Pim Rp-Address

IP Multicast Commands
332
ProSafe Managed Switch
no ip pim bsr-candidate
This command is used to disable the router to announce its candidacy as a bootstrap router
(BSR).
Format no ip pim bsr-candidate interface [vlan | <unit/slot/port>]
Mode
ip pim dr-priority
Use this command to set the priority value for which a router is elected as the designated
router (DR).
Default
Format ip pim dr-priority <0-2147483647>
Mode
no ip pim dr-priority
Use this command to disable the interface from being the BSR border.
Format no ip pim dr-priority
Mode
ip pim join-prune-interval
This command is used to configure the interface join/prune interval for the PIM router. The
join/prune interval is specified in seconds. This parameter can be configured to a value from
0 to 18000.
Default
Format ip pim join-prune-interval <0-18000>
Mode
no ip pim join-prune-interval
Use this command to set the join/prune interval to the default value.
Format no ip pim join-prune-interval
Mode
ip pim rp-address
This command is used to statically configure the RP address for one or more multicast
groups. The parameter <rp-address> is the IP address of the RP. The parameter
Global Config
1
Interface Config
Interface Config
60
Interface Config
Interface Config