Switching Commands
168
ProSafe Managed Switch
When the optional argument detail is used, the command shows the global information
and the information for all Querier-enabled VLANs.
Port Security Commands
This section describes the commands you use to configure Port Security on the switch. Port
security, which is also known as port MAC locking, allows you to secure the network by
locking allowable MAC addresses on a port. Packets with a matching source MAC address
are forwarded normally, and all other packets are discarded.
Note: To enable the SNMP trap specific to port security, see snmp-server
enable traps violation on page 664.
port-security
This command enables port locking at the system level (Global Config) or port level (Interface
Config)
Default
Format port-security
Mode
• Global Config
• Interface Config
.
no port-security
This command disables port locking for one (Interface Config) or all (Global Config) ports.
Format no port-security
Mode
• Global Config
• Interface Config
Last Querier
Address
Indicates the IP address of the most recent Querier from which a Query was received.
Last Querier
Version
Indicates the MLD version of the most recent Querier from which a Query was received
on this VLAN.
disabled
Field Description
To Next Page
Loading...
Need help?
General