NETGEAR ProSAFE M7100-24X - Show Ipv6 Mld-Proxy Groups

IPv6 Multicast Commands
436
ProSafe Managed Switch
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 mld-proxy interface
Interface Index................................ 1/0/1
Ver Query Rcvd Report Rcvd Report Sent Leave Rcvd Leave Sent
------------------------------------------------------------------
1 2 0 0 0 2
2 3 0 4 ----- -----
show ipv6 mld-proxy groups
Use this command to display information about multicast groups that the MLD-Proxy
reported.
Format show ipv6 mld-proxy groups
Mode
• Privileged EXEC
• User EXEC
Example: The following shows example CLI display output for the command.
(Switch) #show ipv6 mld-proxy groups
Interface Index................................ 1/0/3
Group Address Last Reporter Up Time Member State Filter Mode Sources
Leaves Rcvd
Number of MLD leaves received. Valid for version 2 only.
Leaves Sent
Number of MLD leaves sent on the Proxy interface. Valid for version 2 only.
Field Description
Interface
The interface number of the MLD-Proxy.
Group Address
The IP address of the multicast group.
Last Reporter
The IP address of the host that last sent a membership report for the current group,
on the network attached to the MLD-Proxy interface (upstream interface).
Up Time (in secs)
The time elapsed in seconds since last created.
Member State
Possible values are:
• Idle_Member. The interface has responded to the latest group membership query
for this group.
• Delay_Member. The interface is going to send a group membership report to
respond to a group membership query for this group.
Filter Mode
Possible values are Include or Exclude.
Sources
The number of sources attached to the multicast group.
Term Definition