Multicast VLAN Registration (MVR)
213
ProSafe Managed Switch
no mvr vlan
Use this command to exclude the port from the specific MVR group.
show mvr
This command displays global MVR settings.
The following table explains the output parameters.
Example:
(Switch)#show mvr
MVR Running…........................... TRUE
MVR multicast VLAN….................... 1200
MVR Max Multicast Groups….............. 256
MVR Current multicast groups….......... 1
MVR Global query response time…........ 10 (tenths of sec)
MVR Mode….............................. compatible
show mvr members
This command displays the MVR membership groups allocated. <A.B.C.D> is a valid multicast
address in IPv4 dotted notation.
Format no mvr vlan <mVLAN> group <A.B.C.D>
Mode Interface Config
Format show mvr
Mode Privileged EXEC
Term Definition
MVR Running MVR running state. It can be enabled or disabled.
MVR multicast VLAN Current MVR multicast VLAN. It can be in the range from 1 to
4094.
MVR Max Multicast Groups The maximum number of multicast groups supported by MVR.
MVR Current multicast groups The current number of MVR groups allocated.
MVR Query response time The current MVR query response time.
MVR Mode The current MVR mode. It can be compatible or dynamic.
Format show mvr members [<A.B.C.D>]
Mode Privileged EXEC
To Next Page
Loading...
Need help?
General