Switching Commands
140
ProSafe Managed Switch
ip arp inspection vlan
Use this command to enable Dynamic ARP Inspection on a list of comma-separated VLAN
ranges.
Default disabled
Format ip arp inspection vlan vlan-list
Mode
no ip arp inspection vlan
Use this command to disable Dynamic ARP Inspection on a list of comma-separated VLAN
ranges.
Format no ip arp inspection vlan vlan-list
Mode
ip arp inspection validate
Use this command to enable additional validation checks like source-mac validation,
destination-mac validation, and ip address validation on the received ARP packets. Each
command overrides the configuration of the previous command. For example, if a command
enables src-mac and dst-mac validations, and a second command enables IP validation only,
the src-mac and dst-mac validations are disabled as a result of the second command.
Default disabled
Format ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
no ip arp inspection validate
Use this command to disable the additional validation checks on the received ARP packets.
Format no ip arp inspection validate {[src-mac] [dst-mac] [ip]}
Mode
ip arp inspection vlan logging
Use this command to enable logging of invalid ARP packets on a list of comma-separated
VLAN ranges.
Default enabled
Format ip arp inspection vlan vlan-list logging
Mode
Global Config
Global Config
Global Config
Global Config
Global Config
To Next Page
Loading...
