NETGEAR ProSAFE M7100-24X - Chapter 8 Quality of Service (QoS) Commands; Class of Service (CoS) Commands

439
8
8. Quality of Service (QoS) Commands
This chapter describes the Quality of Service (QoS) commands available in the managed
switch CLI.
This chapter contains the following sections:
• Class of Service (CoS) Commands
• Differentiated Services (DiffServ) Commands
• DiffServ Class Commands
• DiffServ Policy Commands
• DiffServ Service Commands
• DiffServ Show Commands
• MAC Access Control List (ACL) Commands
• IP Access Control List (ACL) Commands
• IPv6 Access Control List (ACL) Commands
• Time Range Commands for Time-Based ACLs
• AutoVOIP
• iSCSI Commands
The commands in this chapter are in two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
Class of Service (CoS) Commands
This section describes the commands you use to configure and view Class of Service (CoS)
settings for the switch. The commands in this section allow you to control the priority and
transmission rate of traffic.