Switching Commands
88
ProSafe Managed Switch
If you use the optional parameter statistics <unit/slot/port>, the following dot1x
statistics for the specified port appear.
Port
EAPOL Frames
Received
EAPOL Frames
Transmitted
EAPOL Start
Frames
Received
EAPOL Logoff
Frames
Received
Last EAPOL
Frame Version
Last EAPOL
Frame Source
EAP
Response/Id
Frames
Received
EAP Response
Frames
Received
EAP Request/Id
Frames
Transmitted
EAP Request
Frames
Transmitted
Invalid EAPOL
Frames
Received
EAP Length
Error Frames
Received
show dot1x clients
This command displays 802.1x client information. This command also displays information
about the number of clients that are authenticated using Monitor mode and using 802.1X.
Format show dot1x clients {<unit/slot/port> | all}
Mode
Term Definition
The interface whose statistics are displayed.
The number of valid EAPOL frames of any type that have been received by this
authenticator.
The number of EAPOL frames of any type that have been transmitted by this
authenticator.
The number of EAPOL start frames that have been received by this authenticator.
The number of EAPOL logoff frames that have been received by this authenticator.
The protocol version number carried in the most recently received EAPOL frame.
The source MAC address carried in the most recently received EAPOL frame.
The number of EAP response/identity frames that have been received by this
authenticator.
The number of valid EAP response frames (other than resp/id frames) that have been
received by this authenticator.
The number of EAP request/identity frames that have been transmitted by this
authenticator.
The number of EAP request frames (other than request/identity frames) that have been
transmitted by this authenticator.
The number of EAPOL frames that have been received by this authenticator in which the
frame type is not recognized.
The number of EAPOL frames that have been received by this authenticator in which the
frame type is not recognized.
Privileged EXEC
To Next Page
Loading...
Need help?
General