NETGEAR ProSAFE M7100-24X - Http Port; Https Port

Captive Portal Commands
726
ProSafe Managed Switch
enable
Use this command to globally enable captive portal.
Default disabled
Format enable
Mode
no enable
Use this command to globally disable captive portal.
http port
Use this command to configure an additional HTTP port for captive portal to monitor. The
valid range is from 0 to 65535.
Default
Format http port <0-65535>
Mode
no http port
Use this command to reset the HTTP port to the default number 80.
Format no http port
Mode
https port
Use this command to configure an additional HTTPS port for captive portal to monitor. The
valid range is from 0 to 65535.
Default 443
Format https port <0-65535>
Mode
Captive Portal Configuration mode
Default disabled
Format no enable
Mode
Captive Portal Configuration mode
80
Captive Portal Configuration mode
Captive Portal Configuration mode
Captive Portal Configuration mode