NETGEAR ProSAFE M7100-24X - Dhcp L2 Relay Circuit-ID Vlan; Dhcp L2 Relay Remote-ID Vlan

Switching Commands
126
ProSafe Managed Switch
no dhcp l2relay
Use this command to disable the DHCP Layer 2 relay agent for an interface or range of
interfaces.
Format no dhcp l2relay
Modes
• Global Config
• Interface Config
dhcp l2relay circuit-id vlan
Use this parameter to set the DHCP Option-82 Circuit ID for a VLAN. When enabled, the
interface number is added as the Circuit ID in DHCP option 82. Vlan-list range is 1–4093.
Separate non-consecutive IDs with a comma (,), and do not insert spaces or zeros in
between the range. Use a dash (–) for the range.
Format dhcp l2relay circuit-id vlan <vlan-list>
Mode
no dhcp l2relay circuit-id vlan
Use this parameter to clear the DHCP Option-82 Circuit ID for a VLAN.
Format no dhcp l2relay circuit-id vlan <vlan-list>
Mode
dhcp l2relay remote-id vlan
Use this parameter to set the DHCP Option-82 Remote ID for a VLAN and subscribed service
(based on subscription-name). The vlan–list range is 1–4093. Separate non-consecutive IDs
with a comma (,), and do not insert spaces or zeros between the range. Use a dash (–) for
the range.
Format dhcp l2relay remote-id <remote-id-string> vlan <vlan-list>
Mode
no dhcp l2relay remote-id vlan
Use this parameter to clear the DHCP Option-82 Remote ID for a VLAN and subscribed
service (based on subscription-name).
Format no dhcp l2relay remote-id vlan vlan-list
Mode
Global Config
Global Config
Global Config
Global Config