Quality of Service (QoS) Commands
463
ProSafe Managed Switch
Note: This command fails if any attributes within the policy definition
exceed the capabilities of the interface. Once a policy is successfully
attached to an interface, any attempt to change the policy definition,
that would result in a violation of the interface capabilities, causes
the policy change attempt to fail.
Note: Each interface can have one policy attached.
no service-policy
This command detaches a policy from an interface in the inbound direction. The
<policyname> parameter is the name of an existing DiffServ policy.
Note: This command causes a service to remove its reference to the
policy. This command effectively disables DiffServ on an interface in
the inbound direction. There is no separate interface administrative
'mode' command for DiffServ.
DiffServ Show Commands
Use the DiffServ show commands to display configuration and status information for classes,
policies, and services. You can display DiffServ information in summary or detailed formats.
The status information is only shown when the DiffServ administrative mode is enabled.
Format service-policy {in|out} <policymapname>
Modes
• Global Config
• Interface Config
Format no service-policy in <policymapname>
Modes
• Global Config
• Interface Config
To Next Page
Loading...
