NETGEAR ProSAFE M7100-24X - Spanning-Tree Tcnguard; Spanning-Tree Max-Age; Spanning-Tree Max-Hops

Switching Commands
34
ProSafe Managed Switch
spanning-tree tcnguard
This command enables the propagation of received topology change notifications and topology
changes to other ports.
Default
Format spanning-tree tcnguard
Mode
no spanning-tree tcnguard
This command
disables the propagation of received topology change notifications and topology
changes to other ports.
Format no spanning-tree tcnguard
Mode
spanning-tree max-age
This command sets the Bridge Max Age parameter to a new value for the common and
internal spanning tree. The max-age value is in seconds within a range of 6 to 40, with the
value being less than or equal to 2 x (Bridge Forward Delay - 1).
Default
Format spanning-tree max-age
<6-40>
Mode
no spanning-tree max-age
This command sets the Bridge Max Age parameter for the common and internal spanning
tree to the default value.
Format no spanning-tree max-age
Mode
spanning-tree max-hops
This command sets the MSTP Max Hops parameter to a new value for the common and
internal spanning tree. The max-hops value is a range from 6 to 40.
Default
Format spanning-tree max-hops <1-127>
Mode
disable
Interface Config
Interface Config
20
Global Config
Global Config
20
Global Config