Routing Commands
240
ProSafe Managed Switch
The following shows example CLI display output for the command.
(netgear switch) #show routing heap summary
Heap Size....................... 92594000 bytes
Memory In Use................... 149598 bytes (0%)
Memory on Free List............. 78721 bytes (0%)
Memory Available in Heap........ 92365249 bytes (99%)
In Use High Water Mark.......... 210788 bytes (0%)
Router Discovery Protocol Commands
This section describes the commands you use to view and configure Router Discovery
Protocol settings on the switch. The Router Discovery Protocol enables a host to discover the
IP address of routers on the subnet.
ip irdp
This command enables Router Discovery on an interface.
Default
Format ip irdp
Mode
no ip irdp
This command disables Router Discovery on an interface.
Format no ip irdp
Mode
Parameter Description
Heap Size The amount of memory, in bytes, allocated at startup for the routing heap.
Memory In Use The number of bytes currently allocated.
Memory on Free
List
The number of bytes currently on the free list. When a chunk of memory from the routing heap
is freed, it is placed on a free list for future reuse.
Memory Available
in Heap
The number of bytes in the original heap that have never been allocated.
In Use High Water
Mark
The maximum memory in use since the system last rebooted.
disabled
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General