NETGEAR ProSAFE M7100-24X - Vlan Makestatic; Vlan Name; Vlan Participation

Switching Commands
49
ProSafe Managed Switch
vlan makestatic
This command changes a dynamically created VLAN (one that is created by GVRP
registration) to a static VLAN (one that is permanently configured and defined). The ID is a
valid VLAN identification number. VLAN range is 2-4093.
Format vlan makestatic <2-4093>
Mode
vlan name
This command changes the name of a VLAN. The name is an alphanumeric string of up to 32
characters, and the ID is a valid VLAN identification number. ID range is 1-4093.
Default
• VLAN ID 1 - default
• other VLANS - blank string
Format vlan name <1-4093> <name>
Mode
no vlan name
This command sets the name of a VLAN to a blank string.
Format no vlan name <1-4093>
Mode
vlan participation
This command configures the degree of participation for a specific interface in a VLAN. The
ID is a valid VLAN identification number, and the interface is a valid interface number.
Format vlan participation {exclude | include | auto} <1-4093>
Mode
Participation options are:
include
exclude
auto
VLAN Config
VLAN Config
VLAN Config
Interface Config
Participation
Options
Definition
The interface is always a member of this VLAN. This is equivalent to registration fixed.
The interface is never a member of this VLAN. This is equivalent to registration
forbidden.
The interface is dynamically registered in this VLAN by GVRP. The interface will not
participate in this VLAN unless a join request is received on this interface. This is
equivalent to registration normal.