Quality of Service (QoS) Commands
445
ProSafe Managed Switch
The following information is repeated for each user priority.
User Priority
Traffic Class
show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes for a
specific interface. The unit/slot/port parameter is optional and is only valid on platforms that
support independent per-port class of service mappings. If specified, the IP Precedence
mapping table of the interface is displayed. If omitted, the most recent global configuration
settings are displayed.
Format show classofservice ip-precedence-mapping [<unit/slot/port>]
Mode
The following information is repeated for each user priority.
IP Precedence
Traffic Class
show classofservice ip-dscp-mapping
This command displays the current IP DSCP mapping to internal traffic classes for the global
configuration settings.
Format show classofservice ip-dscp-mapping
Mode
The following information is repeated for each user priority.
IP DSCP
Traffic Class
show classofservice trust
This command displays the current trust mode setting for a specific interface. The
<unit/slot/port> parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If you specify an interface, the command
Term Definition
The 802.1p user priority value.
The traffic class internal queue identifier to which the user priority value is mapped.
Privileged EXEC
Term Definition
The IP Precedence value.
The traffic class internal queue identifier to which the IP Precedence value is mapped.
Privileged EXEC
Term Definition
The IP DSCP value.
The traffic class internal queue identifier to which the IP DSCP value is mapped.
To Next Page
Loading...
Need help?
General