NETGEAR ProSAFE M7100-24X - Lacp Partner Port ID; Lacp Partner Admin State Passive; Lacp Partner Port Priority

Switching Commands
110
ProSafe Managed Switch
lacp partner admin state passive
Use this command to set the LACP partner admin state to passive.
Format lacp partner admin state passive
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner admin state passive
Use this command to set the LACP partner admin state to active.
Format no lacp partner admin state passive
Mode
lacp partner port id
Use this command to configure the LACP partner port id. The valid range for <port-id> is 0
to 65535.
Default
Format lacp partner portid <port-id>
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner port id
Use this command to set the LACP partner port id to the default.
Format no lacp partner portid
Mode
lacp partner port priority
Use this command to configure the LACP partner port priority. The valid range for
<priority> is 0 to 255.
Interface Config
Interface Config
0x80
Interface Config
Interface Config
Default
0x0