Routing Commands
275
ProSafe Managed Switch
no ip ospf database-filter all out
Use this command in Interface Configuration mode to enable OSPFv2 LSA flooding on an
interface.
Default
Format
no ip ospf database-filter all out
Mode
ip ospf dead-interval
This command sets the OSPF dead interval for the specified interface. The value for
<seconds> is a valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers declare that the router
is down. The value for the length of time must be the same for all routers attached to a
common network. This value should be some multiple of the Hello Interval (i.e. 4). Valid
values range in seconds from 1 to 2147483647.
Default
Format ip ospf dead-interval <seconds>
Mode
no ip ospf dead-interval
This command sets the default OSPF dead interval for the specified interface.
Format no ip ospf dead-interval
Mode
ip ospf hello-interval
This command sets the OSPF hello interval for the specified interface. The value for seconds
is a valid positive integer, which represents the length of time in seconds. The value for the
length of time must be the same for all routers attached to a network. Valid values range from
1 to 65535.
Default
Format ip ospf hello-interval <seconds>
Mode
Disabled
Interface Configuration
40
Interface Config
Interface Config
10
Interface Config
To Next Page
Loading...
Need help?
General