Switching Commands
54
ProSafe Managed Switch
no protocol group
This command removes the <vlanid> from this protocol-based VLAN group that is
identified by this <groupid>.
Format no protocol group <groupid> <vlanid>
Mode
protocol vlan group
This command adds the physical interface to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command fails
and the interface(s) are not added to the group.
Default
Format protocol vlan group <groupid>
Mode
no protocol vlan group
This command removes the interface from this protocol-based VLAN group that is identified
by this <groupid>.
Format no protocol vlan group <groupid>
Mode
protocol vlan group all
This command adds all physical interfaces to the protocol-based VLAN identified by
<groupid>. You can associate multiple interfaces with a group, but you can only associate
each interface and protocol combination with one group. If adding an interface to a group
causes any conflicts with protocols currently associated with the group, this command will fail
and the interface(s) will not be added to the group.
Default
Format protocol vlan group all <groupid>
Mode
VLAN Config
none
Interface Config
Interface Config
none
Global Config
To Next Page
Loading...
Need help?
General