IPv6 Commands
376
ProSafe Managed Switch
clear ipv6 statistics
Use this command to clear IPv6 statistics for all interfaces or for a specific interface, including
loopback and tunnel interfaces. IPv6 statistics display in the output of the show ipv6
traffic command. If you do not specify an interface, the counters for all IPv6 traffic
statistics reset to zero.
Format clear ipv6 statistics [{<unit/slot/port> | loopback <loopback-id> |
tunnel <tunnel-id>}]
Mode
OSPFv3 Commands
This section describes the commands you use to configure OSPFv3, which is a link-state
routing protocol that you use to route traffic within a network.
ipv6 ospf
This command enables OSPF on a router interface or loopback interface.
Default
Format ipv6 ospf
Mode
no ipv6 ospf
This command disables OSPF on a router interface or loopback interface.
Format no ipv6 ospf
Mode
ipv6 ospf area
This command sets the OSPF area to which the specified router interface belongs. The
<areaid> is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal
value in the range of <0-4294967295>. The <areaid> uniquely identifies the area to which
the interface connects. Assigning an area id, which does not exist on an interface, causes the
area to be created with default values.
Format ipv6 ospf area <areaid>
Mode
Privileged EXEC
disabled
Interface Config
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General