Captive Portal Commands
739
ProSafe Managed Switch
show captive-portal configuration locales
Use this command to display locales associated with a specific captive portal configuration.
<1-10> is captive port ID.
Format show captive-portal configuration <1-10> locales
Mode
Example
(switch)#show captive-portal configuration 1 locales
Locale Code
---------------
En
show captive-portal trapflags
Use this command to display which captive portal traps are enabled.
Format show captive-portal trapflags
Mode
Example
(switch)#show captive-portal trapflags
Client Authentication Failure Traps............ Disable
Client Connection Traps........................ Disable
Client Database Full Traps..................... Disable
Client Disconnection Traps..................... Disable
Captive Portal Client Connection Commands
This section describes captive portal client connection commands.
show captive-portal client status
Use this command to display client connection details or a connection summary for
connected captive portal users. macaddr is Client MAC address. If no macaddr is entered, all
the client status will be displayed.
Format show captive-portal client [ macaddr ] status
Mode
Privileged EXEC mode
Privileged EXEC mode
Privileged EXEC mode
To Next Page
Loading...
Need help?
General