Quality of Service (QoS) Commands
467
ProSafe Managed Switch
show diffserv service
This command displays policy service information for the specified interface and direction.
The <unit/slot/port> parameter specifies a valid unit/slot/port number for the system.
Format show diffserv service <unit/slot/port> [in | out]
Mode
DiffServ Admin
Mode
Interface
Direction
Operational
Status
Policy Name
Policy Details
show diffserv service brief
This command displays all interfaces in the system to which a DiffServ policy has been
attached. The inbound direction parameter is optional.
Format show diffserv service brief [in | out]
Mode
DiffServ Admin
Mode
The following information is repeated for interface and direction (only those interfaces
configured with an attached policy are shown):
Policy Type
The policy type (Only inbound is supported).
Class Members
List of all class names associated with this policy.
Privileged EXEC
Term Definition
The current setting of the DiffServ administrative mode. An attached policy is only in
effect on an interface while DiffServ is in an enabled mode.
Valid slot and port number separated by forward slashes.
The traffic direction of this interface service.
The current operational status of this DiffServ service interface.
The name of the policy attached to the interface in the indicated direction.
Attached policy details, whose content is identical to that described for the show
policy-map <policymapname> command (content not repeated here for brevity).
Privileged EXEC
Term Definition
The current setting of the DiffServ administrative mode. An attached policy is only active
on an interface while DiffServ is in an enabled mode.
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Direction
The traffic direction of this interface service.
Term Definition
To Next Page
Loading...
Need help?
General