Switching Commands
25
ProSafe Managed Switch
speed all
This command sets the speed and duplex setting for all interfaces.
Format speed all {<100 | 10> <half-duplex | full-duplex>}
Mode
100h
100f
10h
10f
show port
This command displays port information.
Format show port {<unit/slot/port> | all}
Mode
10h
10BASE-T half duplex
10f
10BASE-T full duplex
Global Config
Acceptable
Values
Definition
100BASE-T half duplex
100BASE-T full duplex
10BASE-T half duplex
10BASE-T full duplex
Privileged EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Type
If not blank, this field indicates that this port is a special type of port. The possible
values are:
• Mirror - this port is a monitoring port. For more information, see Port Mirroring on
page 119.
• PC Mbr- this port is a member of a port-channel (LAG).
• Probe - this port is a probe port.
Admin Mode
The Port control administration state. The port must be enabled in order for it to be
allowed into the network. - May be enabled or disabled. The factory default is enabled.
Physical Mode
The desired port speed and duplex mode. If auto-negotiation support is selected, then
the duplex mode and speed is set from the auto-negotiation process. Note that the
maximum capability of the port (full duplex -100M) is advertised. Otherwise, this object
determines the port's duplex mode and transmission rate. The factory default is Auto.
Physical Status
The port speed and duplex mode.
Acceptable
Values
Definition
To Next Page
Loading...
Need help?
General