IPv6 Commands
352
ProSafe Managed Switch
tunnel from the destination address of packets routed into the tunnel. To assign an IP address
to the tunnel interface, see ip address on page 224. To assign an IPv6 address to the tunnel
interface, see ipv6 address on page 355.
interface tunnel
Use this command to enter the Interface Config mode for a tunnel interface. The
<tunnel-id> range is
0 to 7.
Format interface tunnel <tunnel-id>
Mode
no interface tunnel
This command removes the tunnel interface and associated configuration parameters for the
specified tunnel interface.
Format no interface tunnel <tunnel-id>
Mode
tunnel source
This command specifies the source transport address of the tunnel, either explicitly or by
reference to an interface.
Format tunnel source {<ipv4-address> | ethernet <unit/slot/port>}
Mode
tunnel destination
This command specifies the destination transport address of the tunnel.
Format tunnel destination {<ipv4-address>}
Mode
tunnel mode ipv6ip
This command specifies the mode of the tunnel. With the optional 6to4 argument, the tunnel
mode is set to 6to4 automatic. Without the optional 6to4 argument, the tunnel mode is
configured.
Format tunnel mode ipv6ip [6to4]
Mode
Global Config
Global Config
Interface Config
Interface Config
Interface Config
To Next Page
Loading...
Need help?
General