NETGEAR ProSAFE M7100-24X - Show Auto-Voip Interface

Quality of Service (QoS) Commands
489
ProSafe Managed Switch
Note: The administrator has to enable tagging on auto-VoIP-enabled ports
to remark the voice data when it is egressed.
Format auto-voip protocol-based {remark <remark-priority> | traffic-class
<tc>}
Mode
• Global Config
• Interface Config
Default
no auto-voip protocol-based {remark | traffic-class}
This command is used to set the traffic-class to the default value.
Format no auto-voip protocol-based {remark <remark- priority> |
traffic-class <tc>}
Mode
• Global Config
• Interface Config
show auto-voip interface
This command shows the configuration of the auto-voip per port.
Format show auto-voip interface [oui-based|protocol-based]
{<unit/slot/port> | all}
Mode
• Privileged EXEC
• User EXEC
Example 1: If the configured auto-VoIP mode is protocol-based and the traffic-class is
configured.
Auto VoIP VLAN: 2
Interface Admin Auto VoIP Traffic Class
Mode Mode
------------ ------------- ------------------- -------------
0/1 Enabled protocol-based 7
Example 2: If the configured auto-VoIP mode is OUI-based.
Auto VoIP VLAN: 2
Auto VoIP OUI Priority: 7
Interface Admin Auto VoIP
Mode Mode
------------ ------------- ------------
0/1 Enabled oui-based
Traffic-class 7