NETGEAR ProSAFE M7100-24X - MAC Database Commands; Bridge Aging-Time; Show Forwardingdb Agetime; Show Mac-Address-Table Multicast

Switching Commands
200
ProSafe Managed Switch
MAC Database Commands
This section describes the commands you use to configure and view information about the
MAC databases.
bridge aging-time
This command configures the forwarding database address aging timeout in seconds. The
<seconds> parameter must be within the range of 10 to 1,000,000 seconds.
Default
Format bridge aging-time <10-1,000,000>
Mode
no bridge aging-time
This command sets the forwarding database address aging timeout to the default value.
Format no bridge aging-time
Mode
show forwardingdb agetime
This command displays the timeout for address aging.
Default
Format show forwardingdb agetime
Mode
Address Aging
Timeout
show mac-address-table multicast
This command displays the Multicast Forwarding Database (MFDB) information. If you enter
the command with no parameter, the entire table is displayed. You can display the table entry
for one MAC Address by specifying the MAC address as an optional parameter.
Format show mac-address-table multicast <macaddr>
Mode
300
Global Config
Global Config
300s
Privileged EXEC
Term Definition
This parameter displays the address aging timeout for the associated forwarding
database.
Privileged EXEC