Switching Commands
149
ProSafe Managed Switch
no set igmp groupmembership-interval
This command sets the IGMPv3 Group Membership Interval time to the default value.
Format no set igmp groupmembership-interval
Mode
• Interface Config
• Global Config
Format no set igmp groupmembership-interval <vlan_id>
Mode
set igmp maxresponse
This command sets the IGMP Maximum Response time for the system, or on a particular
interface or VLAN. The Maximum Response time is the amount of time in seconds that a
switch will wait after sending a query on an interface because it did not receive a report for a
particular group in that interface. This value must be less than the IGMP Query Interval time
value. The range is 1 to 25 seconds.
Default
Format set igmp maxresponse <1-25>
Mode
• Global Config
• Interface Config
Format set igmp maxresponse <vlan_id> <1-25>
Mode
no set igmp maxresponse
This command sets the max response time (on the interface or VLAN) to the default value.
Format no set igmp maxresponse
Mode
• Global Config
• Interface Config
Format no set igmp maxresponse <vlan_id>
Mode
set igmp mcrtrexpiretime
This command sets the Multicast Router Present Expiration time. The time is set for the
system, on a particular interface or VLAN. This is the amount of time in seconds that a switch
waits for a query to be received on an interface before the interface is removed from the list of
VLAN Config
10 seconds
VLAN Config
VLAN Config
To Next Page
Loading...
