NETGEAR ProSAFE M7100-24X - Show Lacp Actor; Show Lacp Partner; Port-Channel System Priority

Switching Commands
117
ProSafe Managed Switch
port-channel system priority
Use this command to configure port-channel system priority. The valid range of <priority> is
0-65535.
Default
Format port-channel system priority <priority>
Mode
no port-channel system priority
Use this command to configure the default port-channel system priority value.
Format no port-channel system priority
Mode
show lacp actor
Use this command to display LACP actor attributes.
Format show lacp actor {<unit/slot/port>|all}
Mode
The following output parameters are displayed.
System Priority
Admin Key
Port Priority
Admin State
show lacp partner
Use this command to display LACP partner attributes.
Format show lacp partner {<unit/slot/port>|all}
Mode
0x8000
Global Config
Global Config
Global Config
Parameter Description
The system priority assigned to the Aggregation Port.
The administrative value of the Key.
The priority value assigned to the Aggregation Port.
The administrative values of the actor state as transmitted by the Actor in LACPDUs.
Privileged EXEC