Routing Commands
265
ProSafe Managed Switch
area stub no-summary (OSPF)
This command configures the Summary LSA mode for the stub area identified by <areaid>.
Use this command to prevent LSA Summaries from being sent.
Default
Format area <areaid> stub no-summary
Mode
no area stub no-summary
This command configures the default Summary LSA mode for the stub area identified by
<areaid>.
Format no area <areaid> stub no-summary
Mode
area virtual-link (OSPF)
This command creates the OSPF virtual interface for the specified <areaid> and
<neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
Format area <areaid> virtual-link <neighbor>
Mode
no area virtual-link
This command deletes the OSPF virtual interface from the given interface, identified by
<areaid> and <neighbor>. The <neighbor> parameter is the Router ID of the neighbor.
Format no area <areaid> virtual-link <neighbor>
Mode
area virtual-link authentication
This command configures the authentication type and key for the OSPF virtual interface
identified by <areaid> and <neighbor>. The <neighbor> parameter is the Router ID of
the neighbor. The value for <type> is either none, simple, or encrypt. The [key] is
composed of standard displayable, non-control keystrokes from a Standard 101/102-key
keyboard. The authentication key must be 8 bytes or less if the authentication type is simple.
If the type is encrypt, the key may be up to 16 bytes. Unauthenticated interfaces do not need
an authentication key. If the type is encrypt, a key id in the range of 0 and 255 must be
disabled
Router OSPF Config
Router OSPF Config
Router OSPF Config
Router OSPF Config
To Next Page
Loading...
Need help?
General