NETGEAR ProSAFE M7100-24X - Ip Multicast; Ip Multicast Ttl-Threshold

IP Multicast Commands
318
ProSafe Managed Switch
no ip mcast boundary
This command deletes an administrative scope multicast boundary specified by
<groupipaddr> and <mask> for which this multicast administrative boundary is applicable.
<groupipaddr> is a group IP address and <mask> is a group IP mask.
Format
Mode
ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to
active.
Default
Format
Mode
no ip multicast
This command sets the administrative mode of the IP multicast forwarder in the router to
inactive.
Format no ip multicast
Mode
ip multicast ttl-threshold
This command is specific to IPv4. Use this command to apply the given Time-to-Live
threshold value <ttlthreshold> to a routing interface. The <ttlthreshold> is the TTL
threshold which is to be applied to the multicast Data packets which are to be forwarded from
the interface. This command sets the Time-to-Live threshold value such that any data
packets forwarded over the interface having TTL value below the configured value are
dropped. The value for <ttlthreshold> ranges from 0 to 255.
Default
Format ip multicast ttl-threshold <ttlvalue>
Mode
no ip mcast boundary <groupipaddr> <mask>
Interface Config
disabled
ip multicast
Global Config
Global Config
1
Interface Config