IPv6 Commands
389
ProSafe Managed Switch
no default-metric (OSPFv3)
This command is used to set a default for the metric of distributed routes.
Format no default-metric
Mode
distance ospf (OSPFv3)
This command sets the route preference value of OSPF route types in the router. Lower
route preference values are preferred when determining the best route. The type of OSPF
route can be intra, inter, or external. All the external type routes are given the same
preference value. The range of <preference> value is 1 to 255.
Default
Format distance ospf {intra-area <1-255> | inter-area <1-255> | external
<1-255>}
Mode
no distance ospf(OSPFv3)
This command sets the default route preference value of OSPF routes in the router. The type
of OSPF route can be intra, inter, or external. All the external type routes are given the same
preference value.
Format no distance ospf {intra-area | inter-area | external}
Mode
enable (OSPFv3)
This command resets the default administrative mode of OSPF in the router (active).
Default
Format enable
Mode
no enable (OSPFv3)
This command sets the administrative mode of OSPF in the router to inactive.
Format no enable
Mode
Router OSPFv3 Config
110
Router OSPFv3 Config
Router OSPFv3 Config
enabled
Router OSPFv3 Config
Router OSPFv3 Config
To Next Page
Loading...
Need help?
General