NETGEAR ProSAFE M7100-24X - Show Lldp Med Remote-Device

Switching Commands
187
ProSafe Managed Switch
Unknown: False
Tagged: True
Inventory
Hardware Rev: xxx xxx xxx
Firmware Rev: xxx xxx xxx
Software Rev: xxx xxx xxx
Serial Num: xxx xxx xxx
Mfg Name: xxx xxx xxx
Model Name: xxx xxx xxx
Asset ID: xxx xxx xxx
Location
Subtype: elin
Info: xxx xxx xxx
Extended POE
Device Type: pseDevice
Extended POE PSE
Available: 0.3 Watts
Source: primary
Priority: critical
Extended POE PD
Required: 0.2 Watts
Source: local
Priority: low
show lldp med remote-device
This command displays summary information about remote devices that transmit current
LLDP MED data to the system. You can show information about LLDP remote data received
on all ports or on a specific port.
Format show lldp med remote-device {<unit/slot/port> | all}
Mode
Example: The following shows example CLI display output for the command.
(Switch) #show lldp med remote-device all
Privileged EXEC
Term Definition
Interface
The interface in a unit/slot/port format.
Device Class
The Remote device’s MED Classification. There are four different kinds of devices, three
of them represent the actual end points (classified as Class I Generic [IP Communication
Controller etc.], Class II Media [Conference Bridge etc.], Class III Communication [IP
Telephone etc]). The fourth device is Network Connectivity Device, which is typically a
LAN Switch/Router, IEEE 802.1 Bridge, IEEE 802.11 Wireless Access Point etc.