Management Commands
652
ProSafe Managed Switch
specified as an authentication method after radius, no authentication is used if the radius
server is down.
Format aaa authentication dot1x default method1
Mode
method1: At least one from the following table:
local
none
radius
ias
no aaa authentication dot1x
Use this command to remove the authentication at login.
Format no aaa authentication dot1x default
Mode
aaa accounting
The command creates an accounting method list. This list is identified by “default” or a
user-specified “list_name.” Accounting records, when enabled for a line-mode, can be sent at
both the beginning and at the end (start-stop), or only at the end (stop-only). If “none” is
specified, then accounting is disabled for the specified list. If “tacacs” is specified as the
Accounting method, Accounting records are notified to a TACACS+ server. If “radius” is the
specified Accounting method, Accounting records are notified to a RADIUS server.
For the same set of accounting type and list name, the administrator can change the record
type or the methods list without having to first delete the previous configuration.
Note the following:
• A maximum of 5 Accounting Method Lists can be created for each exec and commands
type.
• The same list-name can be used for both exec and commands Accounting type.
• AAA Accounting for commands with RADIUS as the Accounting method is not supported.
Format aaa accounting {exec | commands } {default | list_name} {start-stop
| stop-only |none} method1 [method2…]
Mode
Global Config
Keyword Description
Uses the local username database for authentication.
Uses no authentication.
Uses the list of all RADIUS servers for authentication.
Uses the internal authentication server users database for authentication.
Global Config
Global Config
To Next Page
Loading...
Need help?
General