NETGEAR ProSAFE M7100-24X - Lacp Actor System Priority; Lacp Partner Admin Key

Switching Commands
108
ProSafe Managed Switch
no lacp actor port priority
Use this command to configure the default priority value assigned to the Aggregation Port.
Format no lacp actor port priority
Mode
lacp actor system priority
Use this command to configure the priority value associated with the LACP Actor’s SystemID.
The range for <priority> is 0 to 65535.
Default
Format lacp actor system priority <priority>
Mode
Note: This command is only applicable to physical interfaces.
no lacp actor system priority
Use this command to configure the priority value associated with the Actor’s SystemID.
Format no lacp actor system priority
Mode
lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner.
The valid range for <key> is 0 to 65535.
Default
Format lacp partner admin key
Mode
Note: This command is only applicable to physical interfaces.
Interface Config
32768
Interface Config
Interface Config
0x0
Interface Config