NETGEAR ProSAFE M7100-24X - Captive Portal User Group Commands; User Group (Create); User Group Name; User Group Rename

Captive Portal Commands
750
ProSafe Managed Switch
Captive Portal User Group Commands
The following section describes captive portal user group commands.
user group (Create)
Use this command to create a user group. User group 1 is created by default and cannot be
deleted.
Default
Format user group <1-10>
Mode
no user group
Use this command to delete a user group. The default user group (1) cannot be deleted.
Format user group <1-10>
Mode
user group name
Use this command to configure a group name. <1-10> is the user group ID. The name can be
a string up to 32 characters.
Format user group <1-10> name name
Mode
user group rename
Use this command to change a group's ID to a different group ID.
Format user group group-id rename new-group-id
Mode
1
Captive Portal Configuration mode
Captive Portal Configuration mode
Captive Portal Configuration mode
Captive Portal Configuration mode