Utility Commands
579
ProSafe Managed Switch
no debug dot1x packet
Use this command to disable dot1x packet debug trace.
Format no debug dot1x
Mode
debug igmpsnooping packet
This command enables tracing of IGMP Snooping packets received and transmitted by the
switch.
Default
Format debug igmpsnooping packet
Mode
no debug igmpsnooping packet
This command disables tracing of IGMP Snooping packets.
Format no debug igmpsnooping packet
Mode
debug igmpsnooping packet transmit
This command enables tracing of IGMP Snooping packets transmitted by the switch.
Snooping should be enabled on the device and the interface in order to monitor packets for a
particular interface.
Default
Format debug igmpsnooping packet transmit
Mode
A sample output of the trace message is shown below.
<15> JAN 01 02:45:06 192.168.17.29-1 IGMPSNOOP[185429992]: igmp_snooping_debug.c(116)
908 % Pkt TX - Intf: 1/0/20(20), Vlan_Id:1 Src_Mac: 00:03:0e:00:00:00 Dest_Mac:
01:00:5e:00:00:01 Src_IP: 9.1.1.1 Dest_IP: 225.0.0.1 Type: V2_Membership_Report Group:
225.0.0.1
The following parameters are displayed in the trace message:
Privileged EXEC
disabled
Privileged EXEC
Privileged EXEC
disabled
Privileged EXEC
Parameter Definition
TX
A packet transmitted by the device.
Intf
The interface that the packet went out on. Format used is unit/slot/port (internal interface
number). Unit is always shown as 1 for interfaces on a non-stacking device.
To Next Page
Loading...
Need help?
General