Quality of Service (QoS) Commands
453
ProSafe Managed Switch
To specify the match condition using a numeric notation, one layer 4 port number is required.
The port number is an integer from 0 to 65535.
Default
Format match dstl4port {<portkey> | <0-65535>}
Mode
match ip dscp
This command adds to the specified class definition a match condition based on the value of
the IP DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six
bits of the Service Type octet in the IP header (the low-order two bits are not checked).
The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through
one of the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42,
af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
Note: The ip dscp, ip precedence, and ip tos match conditions are
alternative ways to specify a match criterion for the same Service
Type field in the IP header, but with a slightly different user notation.
match ip precedence
This command adds to the specified class definition a match condition based on the value of
the IP Precedence field in a packet, which is defined as the high-order three bits of the
Service Type octet in the IP header (the low-order five bits are not checked). The precedence
value is an integer from 0 to 7.
Note: The IP DSCP, IP Precedence, and IP ToS match conditions are
alternative ways to specify a match criterion for the same Service
Type field in the IP header, but with a slightly different user notation.
none
Class-Map Config
Ipv6-Class-Map Config
Default
none
Format match ip dscp <dscpval>
Mode
Class-Map Config
Ipv6-Class-Map Config
To Next Page
Loading...
