IP Multicast Commands
324
ProSafe Managed Switch
no ip dvmrp trapflags
This command disables the DVMRP trap mode.
Format no ip dvmrp trapflags
Mode
ip dvmrp
This command sets the administrative mode of DVMRP on an interface to active.
Default
Format ip dvmrp
Mode
no ip dvmrp
This command sets the administrative mode of DVMRP on an interface to inactive.
Format no ip dvmrp
Mode
show ip dvmrp
This command displays the system-wide information for DVMRP.
Format show ip dvmrp
Modes
• Privileged EXEC
• User EXEC
Admin Mode
Version
Total Number of
Routes
Reachable
Routes
The following fields are displayed for each interface.
Global Config
disabled
Interface Config
Interface Config
Term Definition
Indicates whether DVMRP is enabled or disabled.
The version of DVMRP being used.
The number of routes in the DVMRP routing table.
The number of entries in the routing table with non-infinite metrics.
Term Definition
Interface
Valid slot and port number separated by forward slashes.
To Next Page
Loading...
Need help?
General