NETGEAR ProSAFE M7100-24X - Lacp Partner Admin State Individual; Lacp Partner Admin State Longtimeout

Switching Commands
109
ProSafe Managed Switch
no lacp partner admin key
Use this command to configure the administrative value of the Key for the protocol partner.
Format no lacp partner admin key <key>
Mode
lacp partner admin state individual
Use this command to set LACP partner admin state to individual.
Format lacp partner admin state individual
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner admin state individual
Use this command to set the LACP partner admin state to aggregation.
Format no lacp partner admin state individual
Mode
lacp partner admin state longtimeout
Use this command to set LACP partner admin state to longtimeout.
Format lacp partner admin state longtimeout
Mode
Note: This command is only applicable to physical interfaces.
no lacp partner admin state longtimeout
Use this command to set the LACP partner admin state to short timeout.
Format no lacp partner admin state longtimeout
Mode
Note: This command is only applicable to physical interfaces.
Interface Config
Interface Config
Interface Config
Interface Config
Interface Config