Quality of Service (QoS) Commands
441
ProSafe Managed Switch
classofservice trust
This command sets the class of service trust mode of an interface. You can set the mode to
trust one of the Dot1p (802.1p), IP DSCP, or IP Precedence packet markings. You can also
set the interface mode to untrusted. If you configure an interface to use Dot1p, the mode
does not appear in the output of the show running config command because Dot1p is
the default.
Note: The classofservice trust dot1p command will not be supported in
future releases of the software because Dot1p is the default value.
Use the no classofservice trust command to set the mode to the
default value.
no classofservice trust
This command sets the interface mode to the default value.
Format no classofservice trust
Modes
• Global Config
• Interface Config
cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface
queue. The total number of queues supported per interface is platform specific. A value from
0-100 (percentage of link rate) must be specified for each supported queue, with 0 indicating
no guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
Format cos-queue min-bandwidth <bw-0> <bw-1> … <bw-n>
Modes
• Global Config
• Interface Config
Default
dot1p
Format classofservice trust {dot1p | ip-dscp | ip-precedence | untrusted}
Modes
• Global Config
• Interface Config
To Next Page
Loading...
Need help?
General