NETGEAR ProSAFE M7100-24X - Show Ip Access-Lists

Quality of Service (QoS) Commands
478
ProSafe Managed Switch
no ip access-group
This command removes a specified IP ACL from an interface.
Default
Format no ip access-group <accesslistnumber> {{control-plane|in|out}|vlan
<vlan-id> {in|out}}
Mode
• Interface Config
• Global Config
acl-trapflags
This command enables the ACL trap mode.
Default
Format acl-trapflags
Mode
no acl-trapflags
This command disables the ACL trap mode.
Format no acl-trapflags
Mode
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify
the IP ACL.
Format show ip access-lists <accesslistnumber>
Mode
Note: Only the access list fields that you configure are displayed.
Default
none
Format ip access-group {<accesslistnumber>|<name>}
{{control-plane|in|out}|vlan <vlan-id> {in|out}}[sequence
<1-4294967295>]
Modes
• Interface Config
• Global Config
none
disabled
Global Config
Global Config
Privileged EXEC