Switching Commands
79
ProSafe Managed Switch
no dot1x max-users
This command resets the maximum number of clients allowed per port to its default value.
Format no dot1x max-req
Mode
dot1x port-control
This command sets the authentication mode to use on the specified port. Select
force-unauthorized to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select force-authorized to specify that the authenticator
PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
authenticator PAE sets the controlled port mode to reflect the outcome of the authentication
exchanges between the supplicant, authenticator and the authentication server. If the
mac-based option is specified, then MAC-based dot1x authentication is enabled on the port.
Default
Format dot1x port-control {force-unauthorized | force-authorized | auto |
mac-based}
Mode
no dot1x port-control
This command sets the 802.1x port control mode on the specified port to the default value.
Format no dot1x port-control
Mode
dot1x port-control all
This command sets the authentication mode to use on all ports. Select
force-unauthorized to specify that the authenticator PAE unconditionally sets the
controlled port to unauthorized. Select force-authorized to specify that the authenticator
PAE unconditionally sets the controlled port to authorized. Select auto to specify that the
authenticator PAE sets the controlled port mode to reflect the outcome of the authentication
exchanges between the supplicant, authenticator and the authentication server. If the
mac-based option is specified, then MAC-based dot1x authentication is enabled on the port.
Default
Format dot1x port-control all {force-unauthorized | force-authorized | auto
| mac-based}
Mode
Interface Config
auto
Interface Config
Interface Config
auto
Global Config
To Next Page
Loading...
Need help?
General