NETGEAR ProSAFE M7100-24X User Manual

Switching Commands
174
ProSafe Managed Switch
no lldp transmit-tlv
Use this command to remove an optional TLV from the LLDPDUs. Use the command without
parameters to remove all optional TLVs from the LLDPDU.
Format no lldp transmit-tlv [sys-desc] [sys-name] [sys-cap] [port-desc]
Mode
lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs.
Default
Format lldp transmit-mgmt
Mode
no lldp transmit-mgmt
Use this command to include transmission of the local system management address
information in the LLDPDUs. Use this command to cancel inclusion of the management
information in LLDPDUs.
Format no lldp transmit-mgmt
Mode
lldp notification
Use this command to enable remote data change notifications.
Default
Format lldp notification
Mode
no lldp notification
Use this command to disable notifications.
Default
Format no lldp notification
Mode
Interface Config
enabled
Interface Config
Interface Config
disabled
Interface Config
disabled
Interface Config

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English