Captive Portal Commands
744
ProSafe Managed Switch
Example
(switch)#show captive-portal interface configuration status
CP ID CP Name Interface Interface Description Type
----- ------------ --------- ---------------------------- --------
1 Default 1/0/1 Unit: 1 Slot: 0 Port: 1 Gigabit Physical
(switch)#show captive-portal interface configuration 1 status
CP ID..................................... 1
CP Name................................... cp1
Interface Interface Description Type
--------- --------------------------------- --------
1/0/1 Unit: 1 Slot: 0 Port: 1 Gigabit Physical
Captive Portal Local User Commands
The following section describes captive portal local user commands.
user password
Use this command to create a local user or change the password for an existing user. The
user-id is user ID in the range of 1-128. The password is the user password in the range of
8-64 characters. You can also enter encrypted password using the parameter encrypted.
Format user user-id password { password | encrypted enc-password }
Mode
no user
Use this command to delete a user from the local user database. If the user has an existing
session, it is disconnected.
Format no user user-id <1-128>
Mode
Interface
The interface associated with the CP ID.
Interface
Description
The description of the interface
Type
The type of the interface
Captive Portal Configuration mode
Captive Portal Configuration mode
Term Definition
To Next Page
Loading...
Need help?
General