Switching Commands
91
ProSafe Managed Switch
dot1x supplicant max-start
Use this command to configure the number of attempts that the supplicant makes to find the
authenticator before the supplicant assumes that there is no authenticator.
Default
Format dot1x supplicant max-start <1-10>
Mode
no dot1x supplicant max-start
Use this command to set the max-start value to the default.
Format no dot1x supplicant max-start
Mode
dot1x supplicant timeout start-period
Use this command to configure the start period timer interval to wait for the EAP identity
request from the authenticator.
Default
Format dot1x supplicant timeout start-period <1-65535 seconds>
Mode
no dot1x supplicant timeout start-period
Use this command to set the start-period value to the default.
Format no dot1x supplicant timeout start-period
Mode
dot1x supplicant timeout held-period
Use this command to configure the held period timer interval to wait for the next
authentication on previous authentication fail.
Default
Format dot1x supplicant timeout held-period <1-65535 seconds>
Mode
3
Interface Config
Interface Config
30 seconds
Interface Config
Interface Config
30 seconds
Interface Config
To Next Page
Loading...
Need help?
General