NETGEAR ProSAFE M7100-24X User Manual

Utility Commands
565
ProSafe Managed Switch
ip dhcp bootp automatic
This command enables the allocation of the addresses to the bootp client. The addresses are
from the automatic address pool.
Default
Format ip dhcp bootp automatic
Mode
no ip dhcp bootp automatic
This command disables the allocation of the addresses to the bootp client. The address are
from the automatic address pool.
Format no ip dhcp bootp automatic
Mode
ip dhcp conflict logging
This command enables conflict logging on DHCP server.
Default
Format ip dhcp conflict logging
Mode
no ip dhcp conflict logging
This command disables conflict logging on DHCP server.
Format no ip dhcp conflict logging
Mode
clear ip dhcp binding
This command deletes an automatic address binding from the DHCP server database. If “*”
is specified, the bindings corresponding to all the addresses are deleted. <address> is a
valid IP address made up of four decimal bytes ranging from 0 to 255. IP address 0.0.0.0
is invalid.
Format clear ip dhcp binding {<address> | *}
Mode
disabled
Global Config
Global Config
enabled
Global Config
Global Config
Privileged EXEC

NETGEAR ProSAFE M7100-24X Specifications

General

Brand	NETGEAR
Model	ProSAFE M7100-24X
Category	Switch
Language	English