NETGEAR ProSAFE M7100-24X - Show Ip Igmp; Ip Igmp Startup-Query-Count; Ip Igmp Startup-Query-Interval

IP Multicast Commands
341
ProSafe Managed Switch
ip igmp startup-query-count
This command sets the number of Queries sent out on startup, separated by the Startup
Query Interval on the interface. The range for <count> is 1 to 20.
Default
Format ip igmp startup-query-count <count>
Mode
no ip igmp startup-query-count
This command resets the number of Queries sent out on startup, separated by the Startup
Query Interval on the interface to the default value.
Format no ip igmp startup-query-count
Mode
ip igmp startup-query-interval
This command sets the interval between General Queries sent on startup on the interface.
The time interval value is in seconds. The range for <interval> is 1 to 300 seconds.
Default
Format ip igmp startup-query-interval <interval>
Mode
no ip igmp startup-query-interval
This command resets the interval between General Queries sent on startup on the interface
to the default value.
Format no ip igmp startup-query-interval
Mode
show ip igmp
This command displays the system-wide IGMP information.
Format show ip igmp
Modes
• Privileged EXEC
• User EXEC
2
Interface Config
Interface Config
31
Interface Config
Interface Config