NETGEAR ProSAFE M7100-24X - Clear Ipv6 Ospf Neighbor Interface; Clear Ipv6 Ospf Redistribution; Default-Information Originate (Ospfv); Default-Metric (Ospfv)

IPv6 Commands
388
ProSafe Managed Switch
clear ipv6 ospf neighbor interface
To drop adjacency with all neighbors on a specific interface, use the optional parameter
[unit/slot/port]. To drop adjacency with a specific router ID on a specific interface, use the
optional parameter [neighbor-id].
Format clear ipv6 ospf neighbor interface [unit/slot/port] [neighbor-id]
Mode
clear ipv6 ospf redistribution
Use this command to flush all self-originated external LSAs. Reapply the redistribution
configuration and re-originate prefixes as necessary.
Format clear ipv6 ospf redistribution
Mode
default-information originate (OSPFv3)
This command is used to control the advertisement of default routes.
Default
• metric—unspecified
• type—2
Format default-information originate [always] [metric <1-16777214>]
[metric-type {1 | 2}]
Mode
no default-information originate (OSPFv3)
This command is used to control the advertisement of default routes.
Format no default-information originate [metric] [metric-type]
Mode
default-metric (OSPFv3)
This command is used to set a default for the metric of distributed routes.
Format default-metric <1-16777214>
Mode
Privileged EXEC
Privileged EXEC
Router OSPFv3 Config
Router OSPFv3 Config
Router OSPFv3 Config