Management Commands
622
ProSafe Managed Switch
ip telnet server enable
Use this command to enable Telnet connections to the system and to enable the Telnet
Server Admin Mode. This command opens the Telnet listening port.
Default
Format ip telnet server enable
Mode
no ip telnet server enable
Use this command to disable Telnet access to the system and to disable the Telnet Server
Admin Mode. This command closes the Telnet listening port and disconnects all open Telnet
sessions.
Format no ip telnet server enable
Mode
telnet
Use this command to establish a new outbound Telnet connection to a remote host. The host
value must be a valid IP address or host name. Valid values for port should be a valid decimal
integer in the range of 0 to 65535, where the default value is 23. If [debug] is used, the
current Telnet options enabled is displayed. The optional line parameter sets the outbound
Telnet operational mode as ‘linemode’ where, by default, the operational mode is ‘character
mode’. The noecho option disables local echo.
Format telnet <ip-address|hostname> <port> [debug] [line] [noecho]
Modes
• Privileged EXEC
• User EXEC
transport input telnet
Use this command to regulate new Telnet sessions. If enabled, new Telnet sessions can be
established until there are no more sessions available. An established session remains active
until the session is ended or an abnormal network error ends the session.
Note: If the Telnet Server Admin Mode is disabled, Telnet sessions cannot
be established. Use the ip telnet server enable command to
enable Telnet Server Admin Mode.
enabled
Privileged EXEC
Privileged EXEC
To Next Page
Loading...
Need help?
General