Captive Portal Commands
746
ProSafe Managed Switch
user idle-timeout
Use this command to set the session idle timeout value for a captive portal user.
<1-128> is the user ID. The range of idle timeout is 0-900 seconds. 0 indicates use global
configuration.
Default 0
Format user <1-128> idle-timeout timeout
Mode
no user idle-timeout
Use this command to reset the idle timeout to the default value.
Format no user <1-128> idle-timeout timeout
Mode
user max-bandwidth-down
Use this command to configure the bandwidth at which the client can receive data from the
network. <1-128> is the user ID. The range of bps is <0-536870911> bps. 0 indicates use
global configuration.
Default
Format user <1-128> max-bandwidth-down bps
Mode
no user max-bandwidth-down
Use this command to reset the limit to the default.
Format no user <1-128> max-bandwidth-down
Mode
user max-bandwidth-up
Use this command to configure the bandwidth at which the client can send data into the
Network. <1-128> is the user ID. The range of bps is <0-536870911> bps. 0 indicates use
global configuration.
Default 0
Format user <1-128> max-bandwidth-up bps
Mode
Captive Portal Configuration mode
Captive Portal Configuration mode
0
Captive Portal Configuration mode
Captive Portal Configuration mode
Captive Portal Configuration mode
To Next Page
Loading...
Need help?
General