Management Commands
685
ProSafe Managed Switch
delivery and a shared key configured on the client and daemon server to encrypt all
messages.
debug tacacs packet
Use the debug tacacs packet command to turn on TACACS+ packet debug.
Default
Format debug tacacs packet [receive | transmit]
Mode
no debug tacacs packet
Use this command to turn off TACACS+ packet debug.
Format no debug tacacs packet
Mode
tacacs-server host
Use the tacacs-server host command in Global Configuration mode to configure a
TACACS+ server. This command enters into the TACACS+ configuration mode. The
<ip-address|hostname> parameter is the IP address or hostname of the TACACS+
server. To specify multiple hosts, multiple
tacacs-server host commands can be used.
Format tacacs-server host <ip-address|hostname>
Mode
no tacacs-server host
Use the no tacacs-server host command to delete the specified hostname or IP
address. The <ip-address|hostname> parameter is the IP address of the TACACS+
server.
Format no tacacs-server host <ip-address|hostname>
Mode
tacacs-server key
Use the tacacs-server key command to set the authentication and encryption key for all
TACACS+ communications between the switch and the TACACS+ daemon. The
<key-string> parameter has a range of 0 - 128 characters and specifies the
authentication and encryption key for all TACACS communications between the switch and
the TACACS+ server. This key must match the key used on the TACACS+ daemon.
Text-based configuration supports TACACS server’s secrets in encrypted and non-encrypted
format. When you save the configuration, these secret keys are stored in encrypted format
Disabled
Global Config
Global Config
Global Config
Global Config
To Next Page
Loading...
Need help?
General